Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterFurnace Repair in Tampa, FL
Furnace repair in Tampa typically costs between $150 and $600 depending on the failed part, and most repairs can be completed in a single visit. At Meadowsweet Heating and Air Tampa, we service Carrier, Trane, Lennox, and American Standard furnaces, among others, and every repair begins with a written price before any work starts. If your furnace is blowing cold air, short cycling, or making noises it did not make last winter, call us at (728) 212-0500 and a live person will answer, day or night.
Tampa’s climate does not give furnaces a daily workout the way it does in the Midwest, but the humidity and salt air create their own problems. We regularly see rusted flame sensors in Davis Islands homes, corroded control boards near Bayshore Boulevard, and blower motors caked with dust in Carrollwood and Westchase. A furnace that sits idle for months, then gets asked to work hard during a January cold snap, tends to reveal its problems all at once. When that happens, our Heating & Furnace in Tampa team is ready, and so is the rest of our home services team.
Our technicians arrive in uniform, put on shoe covers before stepping inside, and lay drop cloths around the furnace area to keep floors and play spaces clean. That is not an extra charge. It is part of the Cedarwell Care Promise, and it applies on every visit.
When You Need Furnace Repair
Some furnace problems are obvious. Others build slowly until one cold morning the house will not warm up. Here are the specific signs we hear about most from Tampa homeowners:
- The furnace blows cold or lukewarm air. In South Tampa and Seminole Heights, this often points to a failed ignitor or a dirty flame sensor that can no longer confirm the flame. The blower runs, but the air never warms.
- The system short cycles. The furnace starts, runs for two or three minutes, and shuts off. We see this in older New Tampa homes where a clogged filter or failing limit switch causes the unit to overheat and trip its own safety.
- A gas smell near the furnace. If you smell gas, leave the house and call your utility provider first, then call us at (728) 212-0500. Do not flip switches or use anything that could spark. Gas line and burner issues require a trained professional with proper equipment, and this is one repair no one should attempt on their own.
- Strange noises: banging, rattling, or a high-pitched squeal. A rattling panel is usually simple. A banging sound from inside a gas furnace in Citrus Park or Town ‘n’ Country can mean delayed ignition, which needs immediate attention. A squeal usually means a blower motor bearing is failing.
- The furnace runs but rooms stay cold. This can be a duct issue, a failing blower, or a burner that is not firing at full capacity. In older Tampa Heights and Seminole Heights bungalows, we often find disconnected or crushed ductwork in crawl spaces.
- The pilot light or electronic ignitor will not stay lit. Humidity in Tampa accelerates corrosion on thermocouples and flame sensors. If the pilot goes out repeatedly, the issue is rarely just the wind outside.
A furnace that shows any of these signs is telling you something specific. Our job is to listen, diagnose accurately, and explain the fix in plain language before the work begins. No pressure, no vague warnings. Just facts and a written price.
Our Furnace Repair Process
Every furnace repair in Tampa follows the same careful sequence. The goal is not just a working furnace, but a home that looks and feels exactly as it should when we leave.
- You call, a live person answers. When you call (728) 212-0500, you speak to a real person, not a voicemail tree. We ask about the symptoms, confirm your address in Tampa, and schedule a visit window that works around nap times, school pickups, and work schedules whenever possible.
- Diagnosis with a written price before work. The technician arrives in uniform, puts on shoe covers, and gets to work. We test the thermostat signal, ignition sequence, gas pressure, blower operation, and safety limits. Once we know the problem, we write down the exact repair and the exact price. You approve it before we touch a wrench.
- The repair, done carefully around your home. We lay drop cloths under the work area and use quiet tools when kids are napping or pets are nearby. The C.A.R.E. values apply to every visit: Clean up like it’s their own home, Ask before moving anything, Respect your family’s time and quiet hours, and Explain the price before the work.
- System testing after the repair. We run the furnace through complete heating cycles, check the carbon monoxide levels in the exhaust, and verify that the blower and thermostat respond correctly. If the furnace is in a closet near a bedroom or hallway, we pay extra attention to airflow and noise.
- Cleanup and photo confirmation. Before we leave, we clean the work area, remove our tools, and take a photo of the cleaned space. That photo is sent to you as part of the Cedarwell Care Promise. If we moved a filter, we put it back. If we dusted, we dusted everything we touched.
- 365-Day Done Right Promise. Every furnace repair we make in Tampa is covered for a full year. If something is not right, we come back and make it right. No runarounds, no fine print. That is the promise, and it is in writing.
Furnace Repair Pricing in Tampa
Furnace repair costs in Tampa depend on which part failed, how accessible the furnace is, and the brand of equipment. Here are the price ranges we see most often across Hillsborough County:
| Repair Type | Typical Cost in Tampa | Notes |
|---|---|---|
| Flame sensor cleaning or replacement | $120 – $220 | Most common repair in humid Tampa air |
| Ignitor replacement | $180 – $320 | Common on Carrier and Trane gas furnaces |
| Thermostat replacement or rewire | $150 – $350 | Depends on smart thermostat features |
| Blower motor replacement | $350 – $700 | ECM motors cost more than PSC motors |
| Control board replacement | $250 – $550 | More frequent in older Lennox and American Standard units |
| Gas valve replacement | $250 – $500 | Always performed by a trained technician |
| Limit switch or pressure switch | $130 – $260 | Often diagnosed as short cycling |
These are honest ranges, not bait. The final price is written down and approved by you before we start. We do not add trip charges that magically appear later, and we never upsell a replacement when a repair will genuinely solve the problem. If a furnace in a Tampa home is 20 years old with a cracked heat exchanger, we will tell you the truth and talk through your options, but the decision is always yours.
Every estimate is free. When you call (728) 212-0500, the conversation and the visit cost you nothing. If you want a second opinion, we support that. A good repair is one you understand.
FAQs – Furnace Repair in Tampa
How much does furnace repair cost in Tampa?
Furnace repair in Tampa usually costs between $150 and $600, with the most common repairs like flame sensor cleaning and ignitor replacement falling between $120 and $320. The exact price depends on the part that failed, the brand of your furnace, and how difficult the unit is to reach. Call (728) 212-0500 for a free estimate, and we will give you a written price before any work begins.
Can you fix my furnace the same day?
In most cases, yes. We keep common parts for Carrier, Trane, Lennox, and American Standard furnaces on our trucks, so a single visit often completes the repair. If your furnace needs a part that is not on the truck, we order it quickly and keep you updated. When you call (728) 212-0500, we will give you an honest window for when we can arrive.
Is it cheaper to repair or replace a furnace in Tampa?
If the repair costs less than half of a new system and your furnace is under 15 years old, repair is usually the smarter financial choice. A cracked heat exchanger or a system over 20 years old often points toward replacement. We will show you the numbers for both options and let you decide. The estimate is free either way, so call (728) 212-0500 to have a technician take a look.
Do you work on all furnace brands?
We service nine major equipment brands, including Carrier, Trane, Lennox, and American Standard, along with Goodman, Rheem, York, Daikin, and Bryant. Our technicians train on the control boards, gas valves, and ignition systems specific to each brand, so a Lennox repair receives the same careful attention as a Carrier repair. Tell us your brand when you call (728) 212-0500 and we will bring the right diagnostic equipment.
Is furnace repair safe for my kids and pets?
Yes. Our technicians use pet-safe cleaning products, wear shoe covers inside the home, and lay drop cloths around the work area so dirt, dust, and debris never reach play areas or pet beds. We also use quiet tools during nap hours and school time when we can. The Cedarwell Care Promise includes a photo of the clean-up before we leave, so you can see exactly what the work area looked like when we finished.
Call Meadowsweet Heating and Air Tampa for Furnace Repair
When your furnace stops working in Tampa, you want a repair team that respects your home, protects your floors and indoor air, and gives you a price in writing before the first tool comes out. That is exactly how Meadowsweet Heating and Air Tampa works, on every visit, every time. Call us at (728) 212-0500 for a free estimate. A live person answers, 24 hours a day, 7 days a week, no voicemail and no runaround.
Written by Luis Serrano, Owner at Meadowsweet Heating and Air Tampa, serving Tampa.